Waldo

click on one of our sponsors! OR REMOVE ADS

-------------------------------------------------------------------
Hughes IRD Reset Procedure (Models H-0, E-1 & E-2)
-------------------------------------------------------------------
Start off by removing your access card. Select Menu. Select Setup.
Select Installation. Select system test. Right arrow to "begin
test". When test is complete, USING THE REMOTE, Press the
key three times rapidly, followed by pressing twice. (you must do this quickly) A new screen labeled SECRET SYSTEM TEST will appear. This screen on my HIRD-D1 has a button labled "RESET" Pressing this button clears the eprom to factory settings and hard boots the receiver. Then insert your card, and you are ready to go. (Note- not all Hughes receivers have a "reset" button. You might go to this screen and find "DONE" and "Video" keys. This procedure is confirmed to work on the H0, E1, and E2 models. Hughes IRDs D2 and B2 do not work with this FIX...
-------------------------------------------------------------------
Hughes IRD Reset Procedure (Models D-1, D-4, Some E-1 & E-2)
-------------------------------------------------------------------
Remove your access card from the receiver. From the Main Menu go to . Go to option on the menu. Go to the on the menu. Now press three times. Now press two times. A "Secret Menu" will appear, hit . Your receiver will now have reset the eeprom back to original 'unused' state.
-------------------------------------------------------------------
Hughes D-2 Reset Procedure (With temporary push reset switch)
-------------------------------------------------------------------
Lift pin 8 off of board on EEPROM. Solder a wire to pin 8.
Solder another wire to pin 8 trace on board. Solder other end of
the wires to a momentary "ON" push button (Radio shack #275-1547) Mount push button. Remove Access Card. Unplug IRD for 5 seconds. Plug IRD back in. Unplug IRD for 5 seconds. Press and Hold the newly installed Push Button Switch. Plug IRD back in. Wait for "Requesting New Guide" message to appear on TV (this takes about 5 seconds) and then release Push Button Switch. (You may only get the "Please Stand By" message, in this case just wait 5 seconds and release button.) Wait for the "Insert Access Card" Message. Reinsert Access Card & you are now completed.
-------------------------------------------------------------------
Hughes Gold Reset Procedure
-------------------------------------------------------------------
Lift pin 8 off of board on EEPROM. Solder a wire to pin 8.
Solder another wire to pin 8 trace on board. Solder other end of
the wires to a momentary "ON" push button (Radio shack #275-1547) Mount push button. Any time you unplug box now, you must hold down your new button till box starts up, but it will turn off/on normaly as long as you dont unplug it. After you get hit Simply unplug/use powerbar switch on receiver for 5 seconds. Hold down moment switch until receiver powers up again. The receiver will function normally now. If your box is down already you will have to switch cards with someone because this mod doesn't reset the eeprom only write protects it.
-------------------------------------------------------------------
Hughes HIRD-C2 Reset Procedure to work with P2 Series Plastics
-------------------------------------------------------------------
Wire the 10k resistor with 30gauge wire. Power On then short PIN 8 on 24C32 eeprom. Unplug IRD. Plug back in IRD. Insert P1/P3 card channel 100. Remove P1/P3 card. Insert P2 card. You should now have reset the system back to normal.
RCA)

___________________________________________
both my car and my bike can ride on the rear wheel[s]
"Remember one thing, no matter how pretty she is, someone, somewhere, is tired of HER SHIT"